GeoCoder does not show postion after register

After user has registered, corfirms his email and logs in by the first time, the GeoCoder does not show any information (blank). GeoLocator shows default position lat=0 / lon=0.
All other fields are present and filled out correctly.

GeoCoder is updated only when user profile is edited
a) contact info is updated or
b) Geommunity Locator is updated

All further subsequent changes in profile are reported in Geocode properly.
The issue is present directly after registration only.

I am using
CB 2.0.10
Geocoder 2.0.0 Parameter Geocode -> tried both - no difference
Gelocator 2.0.1 Parameter Read Only mode -> enabled
During registration user has to enter the fields according the needed parameter of "Geommunity Geocoder".

Did you have time to check?

Hi

Sorry I missed your first post.
Mostly an incorrect settings. What are the Address fields you use and post a screenshot for the Geocoder plugin settings.
Does it work when editing the profile?

Here are the settings within the CB plugin Geommunity Geocoder.

The issue is present after a user has registered the first time.
Position will only be refreshed when the user updates his profile.
Even just hit the update button in the profile editing section is enough for correct position data.

Locking to the backend in the user details it shows correct adress information.

I just tryed again on this site and got located correctly after registration.
Make sure the plugin is enabled as public.

Good job!
That was the issue.

Make sure the plugin is enabled as public

thanks!